Protecting your power tools from rust can sometimes feel like a full time job. Garages and basements are notoriously hard on tools due to the fact that these high humidity environments provide the perfect conditions for developing rust. By following a few simple procedures you can spend more time woodworking and less time fussing over your rusty tools.

To obtain additional superb advice and also other advice pertaining to woodworking tips go look at my alternative information sites at woodworking plans

Every time you purchase a power tool it is always covered with a waxy and think coating to prevent the rust from eating up your power tools and this is known as cosmoline. But as soon as it riches your place or shop these are being removed and the tools are left unprotected . Often times we strip our power tools of cosmoline without thinking of the need for ongoing protection .

Protecting our power tools would mean that we need to coat them again to keep away moisture. Commercially made rust preventive products can be the easiest way to do it. Boeshield T-9 and the Empire Top Saver are the two most popular brands.Both of these sprays are applied directly to the surface and then rubbed down to remove the excess. This step should be repeated periodically to keep a layer of protection on the tool.

No matter how safely we keep our tools if these are kept without any protection it will still be eaten by rust. And not checking the tools for a long time will eventually lead to more damages.

This jointer was left unprotected. There is already an accumulation of sawdust all over it that can cause rust. After only 2 years, this tool was in need of some care.

The old methods of rust removal generally focused on using abrasives such as steel wool. While this works, it is difficult to get the abrasives into the pits created by rust. Fortunately, there are products available that can make this job a lot easier and more effective.

Here comes Boeshield a rust remover that can make your chore a bit easier. This spray on rust remover works well on the tops of tools that are too large to soak in rust removal solutions. Just spray this all over the rusted areas, wait for a minute then wipe it clean. Using an abrasive tool such as steel wool will aid in removing any rust left.

After following the steps using Rust Free, the jointer is now free of rust and is ready to have the rust preventative applied. If you examine the jointer you will see rust pits that is caused by rusts that was there before cleaning. No method of rust removal can fill in a rust pit once the rust has consumed the metal.

Using these products can be harmful, since rust removals are made of acids to remove the rust fast you should be able to use some protective clothing like goggles and gloves .

Keeping your power tools rust free shouldn't be hard at all just follow the steps provided and you will be all set.